THE INSTALLATION PROCESS

Installation at our fully insured & well-equipped workshop takes approximately 6-7 hours to complete by two trained & approved installers, offering you same day collection.

During the installation process we carefully remove the safety bulkhead, lockable underfloor storage & provide you with these parts for possible re-installation at a future date.

This reveals the area where the M1 tested seat conversion will we installed (See Image 1)

Both inner rear quarter panel upper & lower trims are removed, allowing installation of the two 3-point inertia reel seat belts into the factory locations (See Image 2)

We then prepare the exposed floor area shown in picture above using foam inserts & continue to trim using a high-quality automotive stretch carpet trim as shown (See Image 3)

Next, we carefully refit interior trim panels in preparation for seat installation, the seat conversion is secured to factory fixing locations with the 4 x bolts shown (See Image 3)